Solar inverter Victron Phoenix 300W 24V 230V 50Hz

Product no.: Phoenix 24/350
127.00

Tax included and free shipment to spain



Pura Phoenix Pure Wave Sinusoidal inverter 350W or 375VA 24v for small-sized solar installations.

Details

Great instant power

The SinusMax technology allows to reach a very high instantaneous power, impossible to achieve with conventional high frequency systems. Thus, Phoenix inverters are very suitable for feeding devices that require high starting power, such as refrigerators, freezers, air conditioners and the like.

Power multiplied thanks to the operation in parallel and in three-phase

Up to a total of 6 Phoenix inverters can operate in parallel and thus add their power (certain models, see specifications). For example, six Phoenix 24/3000 together provide a nominal power of 15 kW / 18 kVA. In addition, configurations can be made for three-phase systems using one or more devices for each of the phases.

To change the output to another power source. The automatic switch

If an automatic transfer switch is needed on 1200VA or higher models, we recommend using an equivalent device from the Multi range. The switch is integrated in these devices and its function as charger can be deactivated. For lower power models we recommend our external Filax automatic switch. The change of the Multi and the Filax is done so quickly that it does not cause any alteration in computers or other connected sensitive devices.

Communication port

All models of 1,200 VA and above are equipped with an RS485 communication port. With the MK2 interface and our free software VEConfigure, this port allows you to customize all the Phoenix charger settings (voltage and output frequency, input voltage thresholds ...) and integrate it into computerized control and management networks. VEConfigure also allows programming an internal relay to warn of alarms or start a generator.

Characteristics:

 

  1. Power range: 260-300W
  2. 24V power
  3. Pure wave

The VE.Direct port can be connected to:

 

  • A computer (a VE.Direct to USB interface cable is required)
  • Apple and Android smartphones, tablets, mackbooks and other devices (a VE.Direct a Bluetooth Smart backpack is needed)

 

Fully configurable:

  • Alarm trigger levels and reset by low battery voltage.
  • Levels of disconnection and restart due to low battery voltage.
  • Dynamic disconnection: load dependent disconnection level
  • Output voltage 210 - 245V
  • Frequency 50 Hz or 60 Hz
  • ECO mode on / off and ECO mode level sensor

Tracing:

 

Input / output voltage and current,% of load and alarms
Reliability tested


The complete bridge topology plus toroidal transformer has proven its reliability throughout many years.
The inverters are short-circuit proof and protected against overheating, whether due
at an overload or at a high ambient temperature.


High starting power


Necessary to start loads such as converters for LED lamps, halogen or tools
electric.


ECO mode


In ECO mode, the inverter will be put on hold when the load drops below a value
default (minimum load: 15W). Once on hold, the inverter will be activated briefly (adjustable; default: every 2.5 seconds). If the load exceeds the predetermined level, the inverter will remain switched on.


Remote on / off switch


A remote On / Off switch can be connected to a two-phase connector or between the positive battery and
the left contact of the biphasic connector.


LED diagnosis


Please refer to the manual for its description.
To transfer the load to another AC source: the automatic transfer switch
For our lower power inverters we recommend our transfer switch
Filax automatic The switching time of the “Filax” is very short (less than 20 milliseconds), of so that computers and other electronic equipment will continue to function without interruption

We also recommend

*
Tax included and free shipment to spain

Browse these categories as well: Off grid solar inverters, Full catalogue